2008 2013 toyota highlander rear window wiper blade replacement guide.
Removing rear door panel on toyota highlander.
Remove the front door trim panel.
Disconnect the electrical connectors.
Use the tool slowly with resolution.
Slide a flat bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door 20124.
Insert a large flathead screwdriver or a plastic automotive panel removal tool in between the bottom edge of the door panel and the metal door frame.
About me contact info.
If equipped with power windows remove the door pull handle.
Shown is a 2005 toyota highlander but other years and models are similar.
Back door panel removal on the inside trim you can remove screws that are by the door handle arm rest under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don t want to break them.
You should really acquire a manual that guides you for your particular jag.
Remember to take the panel completely off you need to remove the door handle.
Toyota highlander interior door panel removal guide.
Be careful not to stracth leather or upholstry.
Disconnect and remove power lock window unit usually pries up from one end rear of car and slides out.
Continue pulling out the pop rivets all along the bottom edge and both sides of the door panel.
Gently pry out the courtesy step light bulb housing located at the bottom rear corner of the door panel with the plastic pry bar tool.
The screws may be located behind plugs that you remove with small flat screw driver 2.
Locate screw holes for door handle and other areas maybe and remove.
You ll need to lift the door panel upwards in order to get it off the window ledge.
Look for a plug that has a screw under it.
Get the tool from a parts place and carefully peer into the slot between the door metal and the door panel.
Author webmaster posted on june 10 2014 post navigation.
Remove the one front door trim panel capped screws from the door pull handle.